Skip to content
Loft & Lie Dynamic Fitting Studio
Fitting Services / Loft & Lie

Loft & Lie Fitting

This is the session the studio takes its name from. A bench reading tells you what a club measures at rest. This session tells you what it actually delivers — and the gap between those two numbers is where most golfers' misses live.

The Comparison

Two Numbers, Placed Side by Side

Every session starts with a static bench reading — loft and lie recorded on a club sitting perfectly still, exactly the way most fittings elsewhere stop. From there we add impact tape and a lie board and ask you to swing normally. The marks left behind tell us, in real degrees, how far the delivered number has drifted from the resting one.

That drift isn't a flaw in the club or a sign you're doing something wrong — it's simply information nobody collected before. Once we have it, correcting for it is a bending-machine problem, not a swing-lesson problem.

Loft & Lie Session Data
Static Lie (Bench)degrees
Dynamic Lie (Impact)degrees
Static Loft (Bench)degrees
Dynamic Loft (Impact)degrees
Recommended Benddegrees
Reading the Drift

What a Gap Between the Two Numbers Usually Means

PatternLikely CauseGeneral Direction
Dynamic lie flatter than staticHands set higher at address than posture supportsBend more upright
Dynamic lie more upright than staticHands sitting low, toe hovering at addressBend flatter
Dynamic loft lower than staticForward shaft lean adding loft delofting at impactAdd static loft
Dynamic loft higher than staticScooping motion through impactReduce static loft, revisit setup

This table is a rough map, not a verdict — your actual correction comes from your own impact tape, not a lookup chart.

Session Scope

What's Checked, Club by Club

1

Single Club

One club, checked static and dynamic, with a bend recommendation and a re-test to confirm the correction actually held.

2

Full Iron Set

Every iron gets its own dynamic reading, since lie drift is rarely uniform from the 4-iron down to the pitching wedge.

3

Whole Bag

Woods, hybrids, irons, and wedges all get the same static-versus-dynamic treatment inside one extended appointment.

Put Your Own Clubs on the Bench

Sessions run 60 minutes and include a re-test after any bend, so you leave knowing the correction actually took.